Setup From The Web Browser - Toshiba Magnia Z310 User Manual

Software Access Point
When Not selected is highlighted, only the Toshiba Magnia Software AP (Distribution
System) is released from all LAN cards.
When a wired LAN card is highlighted and the setting is changed to Not selected,
nothing is left bound to the wireless LAN card. Manually bind the necessary protocol
and service. For information about the binding, refer to the OS manual or online
Help.
When newly composing the AFT/ALB team or changing the composition, temporarily
select Not selected in the Wired LAN Selection Utility. After completing the AFT/ALB
composition, reselect the wired LAN card to be connected.
Unless performing the above-mentioned procedure, the communication between a
wireless LAN and wired LAN may not function normally. Should this occur,
reconfigure using the Wired LAN Selection Utility.

Setup from the WEB Browser

Setup from the WEB browser can be used only on the Linux version of the Magnia
Software Access Point.
NOTE: When you use the Linux version of the Magnia Software Access Point from a
wireless LAN station, do not write the information to the access point to which the
station has connected.
3.5.1 Setting change of the WEB browser
For the Linux version of the Magnia Software Access Point, use the WEB browser to
change the settings. When a proxy server has been set in the WEB browser, it may
prevent changes to the settings from being made normally. Disable the proxy server by
changing the WEB browser settings.
When using Internet Explorer
To cancel the proxy server setting when using Internet Explorer, follow the steps below:
354
Utilities