Remote Management And Front Panel Display Setup Tool; Setting Up The Lan Environment - Toshiba Magnia Z310 User Manual

Management Software
NOTE: When setting a trap to InsightManager, keep the following points in mind:
The SEL and Configure Alerts function must be installed.
You need to specify the following settings on the Configure Alerts screen:
Logfile: Application
Event Type: Error or Warning
Event Source: "HEWSEL,HEWMB"
You need to specify the trap destination of the SNMP service. Open the SNMP
Service Properties and select the Traps tab. Specify the IP address of the machine
that installed InsightManager as a trap destination.
For more information, refer to the InsightManager user's guide.
Remote Management and Front Panel Display Setup
Tool
The Remote Management and Front Panel Display Setup Tool is used to set and update
information to enable remote management, and to set display characters on the front
panel display.
To use Remote Management and Front Panel Display Setup Tool, you must first create a
floppy disk using the SST.
Insert this floppy disk into the floppy disk drive, and start up the system. The following
screen displays. Select the desired menu.
1 TOSHIBA Remote Management Setup Tool
2 TOSHIBA Front Panel Display Setup Tool
Enter a choice: 1

Setting up the LAN environment

1 Select 1 on the initial screen to set up a LAN environment.
1 TOSHIBA Remote Management Setup Tool
2 TOSHIBA Front Panel Display Setup Tool
Enter a choice: 1

Remote Management and Front Panel Display Setup Tool

322