Skew Correction Before Punching - Ricoh B230 Training Program

Skew Correction before Punching

Entrance Roller
The entrance roller corrects the skew
SP6103 : Entrance roller stop time
SP6104 : Enable skew correction or not
The finisher entrance roller corrects for paper skew and then the punch unit moves
across to punch the holes at the correct position. Each sheet is punched one at a
time.
Paper feeds out of the copier. The finisher entrance sensor detects the leading
edge of the sheet.
The finisher entrance roller stops rotating briefly while the copier exit rollers continue
to rotate. This buckles the paper against the finisher entrance roller to correct skew.
The finisher entrance roller starts to rotate again and feeds the sheet into the
finisher.
These SP codes adjust the skew operation in the punch unit:
SP6130. This SP corrects the punch hole alignment. To do this, it corrects the skew
of each sheet by adjusting the amount of time the finisher entrance roller remains
off while the exit roller of the machine remains on. For more, see Section "5.
Service Tables".
SP6131. This SP determines whether the finisher entrance roller stops to correct
skew when paper enters the finisher. You can use this SP to disable the skew
correction.
Entrance Sensor
279
279