Embroidery foot/Embroidery needle
Straight-/CutWork stitch plate
Threading lower thread
1
2
Embroidery needle
Embroidery needles (130/705 H-SUK) provide a larger eye and are slightly
rounded. This avoids thread abrasion when using Rayon- and cotton
embroidery thread.
̶ use SUK-needles
̶ depending on the embroidery thread use a size No. 70-SUK to No. 90-SUK
needle
̶ exchange the needle regularly
Preparation
⦁
attach Embroidery foot No. 26 to the embroidery computer
⦁
raise the presser foot
⦁
raise the needle
The Straight-/CutWork stitch plate has a small needle hole in the needle
insertion area. The small needle hole supports the fabric. This optimizes the
stitching results.
⦁
remove the standard stitch plate (see page 27)
⦁
replace it with the straight-/CutWork stitch plate
⦁
pull the thread to the right into the slot 1 and then to the left under the
spring
⦁
hold the thread into the rounding of the bobbin retainer and guide along the
edge to the far right until it hooks in
⦁
guide the thread to the left, pull it over the thread cutter 2 and cut
Push the slide-on table to the left first before the bobbin door is
opened and operations such as changing the bobbin or threading
are carried out.
Checking the thread position
⦁
after threading hold the mirror as illustrated under the swivelled out hook
⦁
position of the lower thread threaded for embroidering
034791.51.04_2014-02_Manual_B880_EN
Preparing for embroidery
155