General
Explanation
Messages
̶ winding a bobbin
̶ too much fabric under presser foot
̶ contact between embroidery computer
and embroidery module is interrupted
due to vibrations
̶ needle position doesn't correspond to
center of hoop
̶ bobbin is inserted incorrectly
̶ bobbin cover is not closed
̶ no bobbin is inserted
̶ threader does not move to starting
position
Repair
⦁
wind bobbin as shown in the animations
⦁
reduce amount of fabric under presser foot
⦁
reconnect embroidery module and switch off and on the
embroidery computer
⦁
calibrate according to User Instructions page 57
⦁
turn over the bobbin, white markings must be visible
⦁
close the bobbin cover slowly
⦁
insert the bobbin
⦁
push the threader carefully to the top
034791.51.04_2014-02_Manual_B880_EN
Troubleshooting
207