Changing The Presser Foot; Removing The Presser Foot; Attaching The Presser Foot; Stitch Plate - Bernina 880 Manual

Changing the presser foot

1

Stitch plate

9 mm
3
5.5 mm (optional accessory)

Removing the presser foot

⦁
⦁
⦁
⦁

Attaching the presser foot

⦁
⦁

Marks on the stitch plate

̶ the stitch plate is marked with vertical, horizontal and diagonal lines in mm
1
̶ the lines help to guide the fabric for sewing seams and precise topstitching,
̶ the horizontal markings are helpful for sewing corners and buttonholes, etc.
̶ the diagonal markings are useful for quilting
̶ needle insertion point is position «0» (center needle position)
̶ the vertical measurements correspond to the distance between the needle
2
̶ measurements are marked to the right and to the left of center needle

Removing the Stitch Plate

⦁
1
⦁
⦁
►

Replacing the Stitch Plate

⦁
2
3
034791.51.04_2014-02_Manual_B880_EN
raise the needle and presser foot
turn power switch to «0» (off)
raise the clamping lever 1
remove the presser foot
guide the presser foot upwards over the cone
press the clamping lever 1 down
and inches
etc.
and the line
position
raise the presser foot and needle
turn power switch to «0» (off)
press the stitch plate down at the right back corner 1 until it flips up
remove stitch plate
place the stitch plate over the opening 2 and press down until it clicks into
place
Exchanging the Stitch Plate
Whenever the stitch plate is exchanged, it is imperative to adjust the
settings in Security Program accordingly, see page 32.
Sewing preparation
27