General
Explanation
Messages
̶ maintaining the sewing-/embroidery
computer
̶ embroidery module has not been
attached yet
̶ embroidery module has not been
correctly attached
̶ no embroidery hoop attached
̶ embroidery hoop attached
̶ the hoop moves
̶ the embroidery process cannot
proceed
̶ embroidery motif is partly outside the
hoop
̶ embroidery motif is too large
̶ embroidering cannot be started
̶ less free space on the USB stick
Repair
⦁
open the bobbin cover and remove the bobbin
⦁
turn sewing-/embroidery computer off
⦁
remove presser foot, needle and stitch plate
⦁
clean the sewing-/embroidery computer as instructed
⦁
connect the embroidery module to the sewing computer
⦁
check the embroidery module connection
⦁
attach the hoop
⦁
remove the hoop
⦁
touch
⦁
move Mega-Hoop to center position and resume
embroidering
⦁
reposition the motif. The area within the hoop can be
embroidered
⦁
reduce the motif size or attach a bigger hoop. The area within
the hoop can be embroidered
⦁
the recommended foot/the recommended stitch plate or an
adequate alternative has to be selected
⦁
delete data from USB stick
034791.51.04_2014-02_Manual_B880_EN
Troubleshooting
to confirm
211