Table of Contents
Advertisement
1
2
4
3
034791.51.04_2014-02_Manual_B880_EN
Altering stitch density 3
Certain decorative stitches (e.g. No. 401) allow an alteration of
the stitch density. The set stitch pattern length will not be
affected.
⦁
touch the «+»-icon
►
the stitch density is reduced in 0.05 mm-steps
►
the stitch distance is increased
⦁
touch the «-»-icon
►
the stitch density is increased in 0.05 mm-steps
►
the stitch distance is decreased
►
touch the «Back»-icon 1
►
the Function Overview appears again
Altering the pattern length 4
⦁
move slider in the Display using the Touchscreen pen or
the finger
►
pattern length (Standard = 100%) is infinitely variable
⦁
extend or shorten in 1%-steps using «+»/«-» or
⦁
touch the «+100%»-icon 2
►
pattern length is extended in 100%-steps
Maximum length is 1000%, shortest length 10%. Some stitch
patterns are limited and cannot be extended to 1000%.
Stitch Counter
⦁
when the desired length is obtained, press the «Quick
reverse»-button
►
the Display changes to «auto»
►
the selected stitch pattern is temporarily programmed
Multi-Directional sewing
⦁
use the stitch width knob to rotate the stitch pattern or
combination in 0.5°-steps, the stitch length knob for
1°-steps or the «Direct-selection»-buttons for 45°-steps
into the desired direction
►
the sewing direction is shown in the left part of the Display
►
the start is marked with a white dot and the end with a red
cross
►
the function only appears if the selected stitch can be sewn
in multiple directions
Long stitch
̶ the sewing computer sews every second stitch (max. stitch
length 12 mm)
̶ applicable for practical and decorative stitches
Exception: buttonholes, alphabets
Functions - Display
43
Advertisement
Table of Contents
