Thread breakage when embroidering
Upper or lower thread breaks
Embroidery sequence control when thread breaks
1
The upper or lower thread may occasionally run out or break when you are
embroidering. When this happens, the embroidery computer stops
automatically, provided that the thread and bobbin indicators are activated in
the Setup-Program.
►
the embroidery computer stops automatically
►
an animation is displayed
⦁
check upper thread
⦁
rethread needle
⦁
check lower thread
⦁
refill or rethread bobbin
⦁
touch the «Embroidery sequence control»-icon
In the left part of the Display the current color of the motif is displayed in normal
size and in the right part the view is enlarged. This makes it easier to check the
embroidery sequence.
►
the message to operate the stitch width and stitch length knobs appears
⦁
turn the knobs to the left or to the right
►
the hoop moves along the embroidery sequence backwards or forwards
⦁
turn the stitch width knob slowly
►
the hoop is moved stitch by stitch
⦁
turn the stitch length knob slowly
►
the hoop is moved in big steps
►
the number in the yellow-framed icon indicates the current position within
the motif by stitch number
⦁
via the «0-9»-icon a position can be entered directly
⦁
position the needle back far enough so that it will resume stitching several
stitches before the thread breakage
Returning to original position
⦁
touch the «Back»-icon 1
►
the Display closes
Resuming embroidery
⦁
press the «Start/Stop/hover»-button or the foot control
The embroidery sequence control is also used for advancing or
backing up in PaintWork, CrystalWork and CutworkDesigns.
034791.51.04_2014-02_Manual_B880_EN
Motifs
201