Bsr (Bernina Stitch Regulator); Quilting With Bsr; Bsr-Function; Bsr Function With Straight Stitch No. 1 - Bernina 880 Manual

BSR

BSR (BERNINA Stitch Regulator)

Quilting with BSR

124

BSR-Function

The BSR presser foot reacts to the movement of the fabric under the foot and
controls the speed of the sewing computer up to the maximum speed possible.
The following applies: the faster the fabric is moved, the higher the speed of
the sewing computer.
If the fabric is moved too fast, an accoustic signal (beep sound) is heard, if the
Beeper is activated (see page 127).
ATTENTION!
As long as the BSR presser foot is illuminated red, adjustments
like threading and changing the needle, for example, must not
be carried out, as the needle will engage while fabric is moved
unintentionally! Without fabric feed the BSR mode is turned off
after approx. 7 seconds and the red light goes off.
Please refer to Safety Instructions!
By activating the BSR function the sewing computer sews
either continuously at reduced speed (mode 1, standard), or as
soon as the fabric is moved (mode 2).

BSR function with straight stitch No. 1

This function using the BSR presser foot, allows for free-motion quilting
(sewing) using the straight stitch and a pre-selected stitch length up to 4 mm.
The regulated set stitch length is maintained within a certain speed,
independent of the movement of the fabric.

BSR function with zig-zag No. 2

The zig-zag can be used e.g. for thread painting. The set stitch length will not
be maintained when sewing with the zig-zag stitch, but the BSR function
simplifies the application.
There are:

Two different BSR modes

̶ BSR 1-Mode is the active standard
̶ the sewing computer runs continuously at a reduced motor speed, as soon
as the foot control or the «Start/Stop»-button is pressed
̶ the speed of the sewing computer is regulated by the movement of the
fabric
̶ through continuous needle movement, securing in the same position is
possible without pressing an additional button
̶ BSR 2-Mode is activated by selecting the «BSR 2»-icon in the «BSR»-
Display
̶ the sewing computer will only engage if the foot control or the «Start/
Stop»-button is pressed and the fabric is moved simultaneously
̶ the speed of the sewing computer is regulated by the movement of the
fabric
̶ to secure press the «Securing function»-button
̶ by selecting the «BSR 1»-icon in the «BSR»-Display Mode 1 is activated
034791.51.04_2014-02_Manual_B880_EN