Pm Display Contents - Toshiba e-STUDIO2330C Service Manual

08-6196 : Current value of PM counter [process unit (Y)]
08-6197 : Current value of PM time counter [process unit (Y)]
08-5564 : Current value of PM counter [process unit (M)]
08-5565 : Current value of PM time counter [process unit (M)]
08-5566 : Current value of PM counter [process unit (C)]
08-5567 : Current value of PM time counter [process unit (C)]
08-5568 : Current value of PM counter [developer material (K)]
08-5569 : Current value of PM time counter [developer material (K)]
08-5570 : Current value of PM counter [developer material (Y)]
08-5571 : Current value of PM time counter [developer material (Y)]
08-5572 : Current value of PM counter [developer material (M)]
08-5573 : Current value of PM time counter [developer material (M)]
08-5574 : Current value of PM counter [developer material (C)]
08-5575 : Current value of PM time counter [developer material (C)]
08-5576 : Current value of PM counter [parts other than the PM parts of the process unit]
08-5577 : Current value of PM time counter [parts other than the PM parts of the process unit]
• Setting value which determines the display conditions
08-223 : Switching of output pages/driving counts at PM [process unit (K)]
08-5578 : Switching of output pages/driving counts at PM [process unit (Y)]
08-5579 : Switching of output pages/driving counts at PM [process unit (M)]
08-5580 : Switching of output pages/driving counts at PM [process unit (C)]
08-5581 : Switching of output pages/driving counts at PM [developer material (K)]
08-5582 : Switching of output pages/driving counts at PM [developer material (Y)]
08-5583 : Switching of output pages/driving counts at PM [developer material (M)]
08-5584 : Switching of output pages/driving counts at PM [developer material (C)]
08-5585 : Switching of output pages/driving counts at PM [parts other than the PM parts of the
process unit]
19.2.3

PM Display Contents

When the counter value exceeds the setting value, the equipment notifies you of when the
maintenance time has come by displaying the message "Time for periodic maintenance ****" on the
control panel LCD. "****" in the message is a 4-digit hexadecimal number code. This number is
allocated in the following manner, therefore the parts needing maintenance can be identified.
PM parts of the process unit (K)
PM parts of the process unit (Y)
PM parts of the process unit (M)
PM parts of the process unit (C)
Developer material (K)
Developer material (Y)
Developer material (M)
Developer material (C)
Parts other than the PM parts of the process unit
If multiple parts have reached the maintenance time, the sum of the corresponding code values listed
above is displayed in hexadecimal numbers.
For example, if the PM parts of the process units (K) and (C) and the developer materials (K) and (C)
reach the maintenance time, the 4-digit hexadecimal number code will be "00CC" in hexadecimal
numbers: 0008+0004+0080+0040=00CC.
19.2.4 Counter Clearing
The counter indicating "current number of prints and driving time" used for the PM display function is
reset by entering "0" in it or clearing it in the PM support mode.
e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C
PREVENTIVE MAINTENANCE (PM)
: 0008
: 0001
: 0002
: 0004
: 0080
: 0010
: 0020
: 0040
: 0100
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
19 - 2