Installing The Printer Controller Module For Pcl6 (Da-Pc300) - Panasonic DP-3030 Service Manual

8.4.

Installing the Printer Controller Module for PCL6 (DA-PC300)

8.4.1. Contents
Qty.
1 Hardware Key
1 Software CD
1
License Agreement
1
1 Installation Instructions
Note:
1.The part number may differ depending on the Destination.
2. Refer to the Parts List in the Parts Manual.
8.4.2. Installation
1. Before installing this option, make sure the Program Expansion Board (DA-EM600) is installed
into Slot 1 on the SC PC Board first. Refer to the Installation Instructions of the Program
Expansion Board (DA-EM600).
2. Install the Hardware Key by following the steps below.
CAUTION!
Turn the Power Switch on the Left Side and the Main Power Switch on the Back of the
machine to the OFF position, and then unplug the AC Power Cord before beginning
installation.
Ver. 2.1
Description Part No.
----- PCL KEY
See Note Includes Operating Instructions
----- For USA and Canada only
----- For Other Destinations
DZSM000692 This document
(1) Remove 4 Silver Screws.
(2) Open the Rear Cover.
Caution:
If the Red LEDs on the SC and SPC PC Boards
are ON, the Power is still ON.
Please read these Installation Instructions once
again.
283
DP-2310/3010
DP-2330/3030
Remarks
MAR 2005