Panasonic DP-3030 Service Manual page 358

1mm
(22)x6
(25)
Ver.2.1
(21) Install the 2 Hinge Covers.
(21)
(22) Peel off the 6 adhesive protectors from the
(24)
(23) Place the Scanning Pad on the glass aligning on
(24) Close the Automatic Document Feeder.
(23)
(25) Lift the ADF Input Tray.
(26) Open the ADF Exit Cover.
(26)
(27) Install the Stamp Unit.
(28) Close the ADF Exit Cover, and lower the ADF
(27)
(29) Perform Service Mode F6 (No. 90, 91, 92, 93
358
Note:
When installing the Hinge Covers, make sure
that each Hinge Film is put inside of each
Hinge Cover.
Scanning Pad.
the upper left corner, keeping 1mm space as
illustrated.
Note:
Re-open the ADF Unit and push the Scanning
Pad gently to paste it properly.
Input Tray.
and 94) to adjust the ADF Scanning Position.
DP-2310/3010
DP-2330/3030
MAR 2005