Installing The Exit Tray [Inner] (Da-Xn200) For Dp-2310/3010 - Panasonic DP-3030 Service Manual

8.24. Installing the Exit Tray [Inner] (DA-XN200) for DP-2310/3010

8.24.1. Contents
Qty.
1 Inner Tray
1 Paper Holder Base
1 Paper Holder
1 Installation Instructions
8.24.2. Installation
CAUTION!
Turn the Power Switch on the Left Side and the Main Power Switch on the Back of the
machine to the OFF position, and then unplug the AC Power Cord before beginning
installation.
Before Installing this Option
<<Perform this step first to avoid overlooking it later>>
Set the Service Parameter to activate the Tray by following the steps below.
1) Press the "FUNCTION", "ORIGINAL SIZE (LEDGER/A3)" and "3" keys simultaneously in that order
to enter the Service Mode.
2) Press the "5" and "START" keys to enter the F5 Mode (Function Parameters).
3) Enter F5-35 "Output Tray (Inner 2)".
4) Press "Yes" key.
5) Press "OK" key twice.
6) Press the "FUNCTION" and "C" (CLEAR) keys simultaneously to exit the Service Mode.
7) Reboot the machine after setting the parameter to activate the setting.
Ver.2.1
Description
342
Part No.
DZML000339
DZJA000782
DZJM000473
DZSM000295
(1) Cut off the Paper Holder at the joint into two
parts with a nipper as illustrated.
Note:
a. Cut the ends neatly.
b. Dispose of the bottom part of the Paper
Holder.
(2) Install the Paper Holder to the Paper Holder
Base which is already installed on the center of
the Jam Cover.
Note:
a. Make sure that the rib side of the Paper
Holder is facing the exit cover.
b. When installing, swing the bottom part of the
Paper Holder to the left as illustrated.
DP-2310/3010
DP-2330/3030
Remarks
This will not be needed
This document
MAR 2005