Table of Contents
Advertisement
STEP 5
Eyelet end
1. With the ball end of the cable to the outside (under weight stack), mount pulley L1 to the
base frame directly behind the weight stack using one 3/8" X 1-3/4" Hex Bolt (118) and one
3/8" Nylon Nut (138) as shown in inset L1. Then route the cable up and around pulley L2
mounted in the second hole in the bottom of the Double Pulley Block (24) using one 3/8" X 1-
3/4" Hex Bolt (118) and one 3/8" Nylon Nut (138) as shown in inset L2.
2. Route the cable down and under a pulley you will now mount in the slot in the Base Frame
(1), using one 3/8" X 2-1/2" Hex Bolt (116) and one 3/8" Washer (130) as shown inset L3.
3. Slide the cable through the Base frame (1) exiting through the hole in the End Cap. Run the
cable through the slot in the front of the Seat Frame (7) and attach the eyelet end of the
cable to Leg Extension Cable Arm (17), using one 3/8" X 3" Hex Bolt (113), and one 3/8"
Nylon Nut (138) as shown in L5.
4. Mount pulley L4 in the slot in the front of the Seat Frame (7), using one
3/8" X 2-3/4" Hex Bolt (114), two 3/8" Bushings (83), two 3/8" Washers
(130) and
L3
L1
Install Leg Extension Cable
LEG EXTENSION CABLE (53)
one 3/8" Nylon Nut (138).
L2
L2
138
65
T9
24
118
130
116
10
Ball end
138
L3
L4
65
7
65
1
130
138
L5
L4
L1
65
118
1
114
130
83
83
113
17
138
L5
Advertisement
Table of Contents
