Cable Arm Assembly - BodyCraft MA605 Assembly Instructions Manual

STEP 3 ASSEMBLE CABLE ARM
Remember to keep all BOLTS loose to ensure the holes will align easily.
1. Attach the Cable Arm Assembly (18) to the Main Frame (1), using two 1/2" X 3-1/4" Hex
Bolts (130), four 1/2" Smaller Washers (161) and two 1/2" Nylon Nuts (169).
2. Attach Cable Arm Assembly (18) to the Cable Arm Connector (19), using two 3/8" X 1"
Hex Threaded Bolts (137) and two 3/8" Washers (163). Then attach the Cable Arm
Connector (19) to Front Upright (3), using one 1/2" X 2-3/4" Hex Bolt (131) and one 1/2"
Smaller Washer (161).
3. Insert the Axle of each Cable Arm (16) into the holes of the axle plates on the Cable Arm
161
130
Assembly (18) and fasten using the Collars (51). Tighten the 5/16' X
1/4" Set Screw (158) on the Collars (51).
Check to ensure that both Cable Arms (16) pivot
51
3
161
1
161
130
freely and cables are not twisted.
51 18
158
169
161
131
16
8
16
47
19
169
161
163
137
47
163
137