[Stamp Settings] ([System Settings]); [Header/Footer Settings] - Muratec MFX-C2280 Fax Manual

Select whether to reset settings for the conditions that are applied when changing users or loading a docu-
ment to the ADF.
Settings
[When Account is changed]
[When original is set on
ADF]
[Next Job]
[Default Basic/Enlarge Dis-
play Common Setting]

[Stamp Settings] ([System Settings])

To display: [Utility] - [Administrator Settings] - [System Settings] - [Stamp Settings]
Register header/footer programs and specify the stamp setting when sending a fax.
Settings

[Header/Footer Settings]

[Fax TX Settings]
[Header/Footer Settings]
To display: [Utility] - [Administrator Settings] - [System Settings] - [Stamp Settings] - [Header/Footer Settings]
- [New]
You can register header/footer programs, and change or delete registered programs.
Settings
[Name]
[Header Settings]
Description of Setup Buttons (Administrator Settings)
Description
Select whether to initialize all settings (except registered settings) when the
key counter or management card is removed.
[Reset] is specified by default.
Select whether to reset all settings (except registered settings) when doc-
ument is loaded on the ADF.
[Do Not Reset] is specified by default.
Select whether to reset Staple Setting, Original Set/Bind Direction settings,
and TX Settings for each job.
• [Staple Setting]: Select whether to inherit the settings to the next job or
cancel the settings after a job with Staple specified has been ended.
[OFF] is specified by default.
• [Original Set/Bind Direction]: Select whether to inherit the settings to
the next job or cancel the settings after a job with Original Set and Bind
Direction specified has been ended.
[OFF] is specified by default.
• [Reset Data After Job]: Select whether to clear all settings or only des-
tinations when resetting for each job in Scan/Fax TX Settings. If you se-
lect [Confirm with User], a confirmation screen appears to check with
you if settings or destinations are to be cleared.
[Reset All] is specified by default.
Select whether to configure the initial values for Normal and Enlarge Dis-
play mode at the same time.
If [Apply to all] is selected, [Default Enlarge Display Settings] does not ap-
pear. Initial values for each mode that are changed in [Default Copy Set-
tings] or [Default Scan/Fax Settings] are applied to both Normal and
Enlarge Display modes.
[Do not Apply] is specified by default.
Description
You can register header/footer programs, and change or delete registered
programs.
For details on settings, refer to page 11-9.
Select whether to cancel stamp setting when sending a fax.
For details on settings, refer to page 11-10.
Description
Enter the name of header/footer program (using up to 16 characters).
When selecting a header or footer, give it a name that helps you easily
identify it.
Select whether to print a header. To print it, specify what to print.
• [Text]: Characters you entered are printed.
• [Date/Time]: Select whether to print date and time. To print it, select the
appropriate display format.
• [Other]: Select whether to print information, such as job number, ma-
chine's serial number, and distribution control number.
[Do Not Print] is specified by default.
11
11-9