Ap Policy - ZyXEL Communications NXC2500 User Manual

7.3.4 AP Policy

Use this screen to configure the AP controller's IP address on the managed APs and determine the
action the managed APs take if the current AP controller fails. Click Configuration > Wireless >
AP Management > AP Policy to access this screen.
Figure 50 Configuration > Wireless > AP Management > AP Policy
Each field is described in the following table.
Table 52 Configuration > Wireless > AP Management > AP Policy
LABEL
Force Override AC
IP Config on AP
Override Type
Primary Controller
Secondary
Controller
Fall back to Primary
Controller when
possible
Fall Back Check
Interval
Firmware Updating
Updating Type
Chapter 7 Wireless
DESCRIPTION
Select this to have the NXC change the AP controller's IP address on the managed AP(s)
to match the configuration in this screen.
Select Auto to have the managed AP(s) automatically send broadcast packets to find
any other available AP controllers.
Select Manual to replace the AP controller's IP address configured on the managed
AP(s) with the one(s) you specified below.
Specify the IP address of the primary AP controller if you set Override Type to
Manual.
Specify the IP address of the secondary AP controller if you set Override Type to
Manual.
Select this option to have the managed AP(s) change back to associate with the
primary AP controller as soon as the primary AP controller is available.
Set how often the managed AP(s) check whether the primary AP controller is available.
Specify how you want the NXC to upgrade AP firmware.
Select CAPWAP to have the NXC use CAPWAP to automatically update firmware on the
managed APs.
Select FTP to allow the managed APs to download the latest firmware from the NXC
using FTP.
NXC Series User's Guide
101