Layer-2 Isolation List - ZyXEL Communications NXC2500 User Manual

Figure 128 SSID > MAC Filter List > Add/Edit MAC Filter Profile
The following table describes the labels in this screen.
Table 116 SSID > MAC Filter List > Add/Edit MAC Filter Profile
LABEL
Profile Name
Filter Action
Add
Edit
Remove
#
MAC
Description
OK
Cancel

18.3.4 Layer-2 Isolation List

This screen allows you to create and manage layer-2 isolation profiles that can be used by your
SSIDs. To access this screen click Configuration > Object > AP Profile > SSID > Layer-2
Isolation List.
If a device's MAC addresses is NOT listed in a layer-2 isolation profile, it is blocked from
communicating with other devices in an SSID on which layer-2 isolation is enabled.
Note: You can have a maximum of 32 layer-2 isolation profiles on the NXC.
Chapter 18 AP Profile
DESCRIPTION
Enter up to 31 alphanumeric characters for the profile name. This name is only visible in the
Web Configurator and is only for management purposes. Spaces and underscores are
allowed.
Select allow to permit the wireless client with the MAC addresses in this profile to connect to
the network through the associated SSID; select deny to block the wireless clients with the
specified MAC addresses.
Click this to add a MAC address to the profile's list.
Click this to edit the selected MAC address in the profile's list.
Click this to remove the selected MAC address from the profile's list.
This field is a sequential value, and it is not associated with a specific profile.
This field specifies a MAC address associated with this profile.
This field displays a description for the MAC address associated with this profile. You can click
the description to make it editable. Enter up to 60 characters, spaces and underscores
allowed.
Click OK to save your changes back to the NXC.
Click Cancel to exit this screen without saving your changes.
NXC Series User's Guide
228