Controller - ZyXEL Communications NXC2500 User Manual

7.2 Controller

Use this screen to set how the NXC allows new APs to connect to the network. Click Configuration
> Wireless > Controller to access this screen.
Figure 45 Configuration > Wireless > Controller
Each field is described in the following table.
Table 47 Configuration > Wireless > Controller
LABEL
Country Code
Registration
Type
Apply
Reset
Chapter 7 Wireless
DESCRIPTION
Select the country where the NXC is located/installed.
Select Manual to add each AP to the NXC for management, or Always Accept to
automatically add APs to the NXC for management.
Note: Select the Manual option for managing a specific set of APs. This is recommended as the
registration mechanism cannot automatically differentiate between friendly and rogue
APs. For details on how to handle rogue APs, see
APs must be connected to the NXC by a wired connection or network.
Click Apply to save your changes back to the NXC.
Click Reset to return the screen to its last-saved settings.
NXC Series User's Guide
Section 5.15 on page
93
83.