Add/Edit Policy Route - ZyXEL Communications NXC2500 User Manual

Table 67 Configuration > Network > Routing > Policy Route (continued)
LABEL
DSCP Code
Service
Source Port
Next-Hop
DSCP Marking
SNAT
Apply
Reset

9.2.1 Add/Edit Policy Route

Click Configuration > Network > Routing to open the Policy Route screen. Then click the Add
or Edit icon to open the Policy Route Edit screen. Use this screen to configure or edit a policy
route.
Chapter 9 Policy and Static Routes
DESCRIPTION
This is the DSCP value of incoming packets to which this policy route applies.
any means all DSCP values or no DSCP marker.
default means traffic with a DSCP value of 0. This is usually best effort traffic
The "af" entries stand for Assured Forwarding. The number following the "af" identifies one
of four classes and one of three drop preferences.
The "wmm" entries are for QoS. For more information on QoS and WMM categories, see
page 146.
This is the name of the service object. any means all services.
This is the name of a service object. The NXC applies the policy route to the packets sent
from the corresponding service port. any means all service ports.
This is the next hop to which packets are directed. It helps forward packets to their
destinations and can be a router or outgoing interface.
This is how the NXC handles the DSCP value of the outgoing packets that match this route.
If this field displays a DSCP value, the NXC applies that DSCP value to the route's outgoing
packets.
preserve means the NXC does not modify the DSCP value of the route's outgoing packets.
default means the NXC sets the DSCP value of the route's outgoing packets to 0.
The "af" choices stand for Assured Forwarding. The number following the "af" identifies one
of four classes and one of three drop preferences.
The "wmm" entries are for QoS. For more information on QoS and WMM categories, see
page 146.
This is the source IP address that the route uses.
It displays none if the NXC does not perform NAT for this route.
Click Apply to save your changes back to the NXC.
Click Reset to return the screen to its last-saved settings.
NXC Series User's Guide
141