Configuring The Quad Bri Network Interface; Configuring The Pri Network Interface - Polycom ViewStation EX Administrator's Manual

Configuring the Quad BRI Network Interface

Configuring the PRI Network Interface

© Polycom, Inc.
To configure the ISDN Network settings:
1. Go to System Info > Admin Setup > Video Network > ISDN Network.
2. Configure these settings:
Setting Description
Country Code Specifies the country code for this system's location.
Area Code Specifies the area code or STD for this system's location.
Number A Specifies the primary and secondary ISDN numbers assigned to
this system.
Number B
ISDN Switch Specifies the ISDN switch protocol used by the network. Contact
Protocol your ISDN network service provider for this information.
ISDN Dialing Prefix Specifies the number to dial to access numbers outside the PBX.
If the system is not located on a PBX, leave this field blank.
To use the PRI network interface, you must configure the following:
!
PRI network support
!
PRI channels
!
PRI information
Your ISDN service provider can tell you which protocol your network uses. If you later
change the country setting, the PRI switch protocols available may also change, and you
may be prompted to configure a different PRI switch protocol.
Chapter 3 - Configuring Network Use
3-15