Setting The Link Monitor Period - Wi-LAN Hopper Plus 120-24 Installation And Configuration Manual

Setting the Link Monitor Period

The Link Monitor Period determines the ratio of test data to message data that is sent when you run the link
monitor test. The higher the period number, the smaller the ratio of test data to message data. The following
diagram shows the ratios of test data to link data
Link Monitor Period Settings
Period Setting
1
2
3
See Performing Link Monitor Test (Normal
➧
To set Link Monitor Period
1. From the Main Menu, select RF Station Configuration and press
Configuration menu is displayed.
Operating Mode
RF Transmit Status
Link Monitor Period (0=OFF, 1-10000)
Test Mode Timer Minutes (1-1000)
Base Station Only Parameters
Maximum Remote Distance
Link Monitor Remote Station Rank
Remote Station Only Parameters
Throttle Enable
Throttle Level (1-50)
2. Select Link Monitor Period and press
3. Type the period setting (0=OFF, 1-10000)
4. Press . The test starts as soon as a non-zero value is entered.
Enter
5. Press to exit to the Main Menu.
Esc
DEC 2000 Rev 02
Test Msg
Test Msg
Test Msg
Test = test data
Msg = message data
Mode), page 52 for information about running the Link Monitor test.
RF Station Configuration
Enter
Msg
Msg Msg
Normal Mode
unblocked
-> 1
5
5 Km
1
off
1
. The data field highlights.
RF Station Configuration
Packet Ratio
(Test/Link)
50% (1/2)
33.3% (1/3)
25% (1/4)
. The RF Station
Enter
59