Wi-LAN Hopper Plus 120-24 Installation And Configuration Manual page 92

Configuration
➧
To save current configuration to FLASH
1. From the Main Menu, select Radio Module Configuration and press
Configuration menu is displayed.
Station Type
Station Rank (1-1000)
Center Frequency
Security Password 1
Security Password 2
Security Password 3
Security Password 4
Security Password 5
Scrambling Code
Acquisition Code
Config Test Minutes
Base Station Only Parameters
Repeater Mode
System Symmetry Type
Dynamic Polling Level (1-100)
Remote Station Only Parameters
Remote Unit RF Group (0-63)
Reboot New RF configuration
Save Current Config to Flash
2. Select Save Current Config to Flash.
3. Press . The current configuration is saved to flash memory. A reboot is not required. The new flash
Enter
memory values are displayed in the "Flash" column of the Radio Module Configuration menu.
80
Radio Module Configuration
New
Remote Unit
1
2.4400 GHz
(Hex) 1
(Hex) 10
(Hex) 100
(Hex) 1000
(Hex) 10000
(Hex) 0
(0-15) 1
(1-120) 30
off
Asymmetric
1
0
Press Enter to Execute
-> Press Enter to Execute
Enter
Current Flash
Remote Unit Remote Unit
1 1
2.4400 GHz 2.4400 GHz
1 1
10 10
100 100
1000 1000
10000 10000
0 0
1 1
30 30
off off
Asymmetric Asymmetric
0 0
Hopper Plus 120-24 Installation & Configuration Guide
. The Radio Module