Wi-LAN Hopper Plus 120-24 Installation And Configuration Manual page 21

Items located on the back panel are described below.
ANTENNA Connector
POWER Connector
MODE Button
10/100BASET
LINK LED
DEC 2000 Rev 02
TNC antenna port is located at the top left of the rear panel. This port
should always be connected to an antenna directly or through a 50 ohm
coaxial cable
3-pin power connector. See
pinout illustration
Mode button can be used to set the operating mode of a unit without a
terminal. See Setting Operating Mode with the MODE
information about the mode button
Standard RJ45 female connector. To connect to a PC Ethernet card, you must
use the crossover twisted-pair cable. To connect to a hub, use a straight-
through twisted-pair cable
Color of LED indicates the data rate and status of the twisted-pair
connection
Green = 10BaseT link, functioning properly
Orange = 100BaseT link, functioning properly
Off = No link
DC Power Plug Pinout, page 148 for detailed
Hardware Description
Button, page 97 for
9