Accessing The Main Menu - Wi-LAN Hopper Plus 120-24 Installation And Configuration Manual

Configuration

Accessing the Main Menu

You can access the Main Menu of a Hopper Plus unit with a HyperTerminal ® session (via the MANAGEMENT
port) or a telnet session. Most instructions provided in this chapter assume that you have opened a
HyperTerminal session.
You can also configure the Hopper Plus 120-24 remotely with the SNMP (Simple Network Management
Protocol). See Appendix D:
Accessing the Main Menu with HyperTerminal ®
To access the Main Menu with HyperTerminal
1. Disconnect power from the Hopper Plus unit.
2. Connect a serial cable from a DB9 serial port on the PC to the MANAGEMENT port on the Hopper
Plus. See Configuring a Base
3. Start Hyperterminal or another terminal emulation program on the PC. See
HyperTerminal.
4. Set the terminal emulation program to emulate a VT100 terminal with the following settings.
• COM port
• Bits per second:
• Data bits:
• Parity:
• Stop bits:
• Flow control:
5. Reconnect the power to the Hopper Plus unit.
6. Press . The Wi-LAN Hopper Plus 120-24 Login menu is displayed.
Enter
Wi-LAN Hopper Plus 120-24 Login
Software:
Hardware:
Enter Password:
7. Type a default password (user or supervisor) or type your personal password if already have one.
Login Account
User
Supervisor
The Main Menu is displayed.
32
SNMP, page 133 for information about SNMP.
Station, page 16.
PC serial port connected to Hopper Plus unit
9600
8
none
1
none
Rev 0.0.0 (May 25 2000 10:13:37)
Rev 0.0.0 (4MB SDRAM, 4MB Intel Flash)
Default Password
user
supervisor
Appendix B: Using
Privileges
Read Only
Read and Write
Hopper Plus 120-24 Installation & Configuration Guide