Accessing Units Via Telnet - Wi-LAN Hopper Plus 120-24 Installation And Configuration Manual

Accessing Units via telnet

To access units via telnet
1. Ensure that the unit's Internet IP address has been configured, the unit has a working Ethernet
connection, and wire and remote access has been enabled (see
page 89).
2. Ensure that the VT100 Arrows feature in your telnet session is enabled. See
3. From the DOS prompt, type
C:>telnet <IP address>
where <IP address> is the IP address of the unit that you want to configure.
4. Press . The Login menu is displayed.
Enter
Wi-LAN Hopper Plus 120-24 Login
Software:
Hardware:
Enter Password:
5. Type the default password (user or supervisor) or type your personal password.
The Main Menu is displayed.
Setting VT100 Arrows
To set the VT100 arrows in Microsoft telnet
1. In the active Microsoft telnet 1.0 session, select Terminal, Preferences from the menu bar. The
Terminal Preferences window is displayed.
2. Click the VT100 Arrows checkbox.
3. Click OK. The VT100 arrows are enabled in the telnet session.
You can now use the keyboard arrow keys to navigate the configuration menus.
DEC 2000 Rev 02
Rev 0.0.0 (May 25 2000 10:13:37)
Rev 0.0.0 (4MB SDRAM, 4MB Intel Flash)
Accessing the Main Menu
Allowing Remote Access and
Setting VT100
Configuration,
Arrows, page 33.
33