Setting The Center Frequency - Wi-LAN Hopper Plus 120-24 Installation And Configuration Manual

Configuration

Setting the Center Frequency

The center frequency defines the channel a unit uses to transmit and receive. To ensure communication
between units, all units in a system must have the same center frequency value.
➧
To set the center frequency
1. From the Main Menu, select Radio Module Configuration and press
Configuration menu is displayed.
Station Type
Station Rank (1-1000)
Center Frequency
Security Password 1
Security Password 2
Security Password 3
Security Password 4
Security Password 5
Scrambling Code
Acquisition Code
Config Test Minutes
Base Station Only Parameters
Repeater Mode
System Symmetry Type
Dynamic Polling Level (1-100)
Remote Station Only Parameters
Remote Unit RF Group (0-63)
Reboot New RF configuration
Save Current Config to Flash
2. Select Center Frequency and press
3. Scroll to select the RF center frequency to apply to all units in the network.
4. Press . The new setting is displayed in the "New" column.
Enter
5. Select Reboot New RF Configuration and press
120-24 Login menu is displayed. The unit now runs using the "Current" center frequency for the
amount of time specified by the Current Test Minutes.
6. To save the current setting(s) to flash memory, log in, go to the Main Menu, and select Radio Module
Configuration, Save Current Config to Flash. See
Configurations, page
7. Press to exit to the Main Menu.
Esc
68
Radio Module Configuration
-> 2.4400 GHz
(Hex)
(Hex)
(Hex)
(Hex)
(Hex)
(Hex)
(0-15)
(1-120)
Enter
79.
New Current
Remote Unit Remote Unit
1 1
2.4400 GHz
1 1
10 10
100 100
1000 1000
10000 10000
0 0
1 1
30 30
off off
Asymmetric Asymmetric
1
0 0
Press Enter to Execute
Press Enter to Execute
. The data field highlights.
. The unit reboots and the Hopper Plus
Enter
Rebooting and Saving RF Module
Hopper Plus 120-24 Installation & Configuration Guide
. The Radio Module
Enter
Flash
Remote Unit
1
2.4400 GHz
1
10
100
1000
10000
0
1
30
off
Asymmetric
0