Wi-LAN Hopper Plus 120-24 Installation And Configuration Manual page 85

➧
To set base to repeater mode
1. From the Main Menu, select Radio Module Configuration and press
Configuration menu is displayed.
Station Type
Station Rank (1-1000)
Center Frequency
Security Password 1
Security Password 2
Security Password 3
Security Password 4
Security Password 5
Scrambling Code
Acquisition Code
Config Test Minutes
Base Station Only Parameters
Repeater Mode
System Symmetry Type
Dynamic Polling Level (1-100)
Remote Station Only Parameters
Remote Unit RF Group (0-63)
Reboot New RF configuration
Save Current Config to Flash
2. Select Repeater Mode and press
3. Scroll to select the desired setting where:
off
on
4. Press . The new setting is displayed in the "New" column.
Enter
5. Select Reboot New RF Configuration and press
120-24 Login menu is displayed. The unit now runs using the "Current" repeater mode for the amount
of time specified by the Current Test Minutes.
6. To save the current setting(s) to flash memory, log in, go to the Main Menu, and select Radio Module
Configuration, Save Current Config to Flash. See
Configurations, page
7. Press to exit to the Main Menu.
Esc
DEC 2000 Rev 02
Radio Module Configuration
(Hex)
(Hex)
(Hex)
(Hex)
(Hex)
(Hex)
(0-15)
(1-120)
-> off
. The data field highlights.
Enter
Base unit does not re-transmit messages—default setting
Base unit re-transmits messages received from one remote to
other remotes in same RF group
79.
New Current
Remote Unit Remote Unit
1 1
2.4400 GHz 2.4400 GHz
1 1
10 10
100 100
1000 1000
10000 10000
0 0
0 0
30 30
off
Asymmetric Asymmetric
1
0 0
Press Enter to Execute
Press Enter to Execute
. The unit reboots and the Hopper Plus
Enter
Radio Module Configuration
. The Radio Module
Enter
Flash
Remote Unit
1
2.4400 GHz
1
10
100
1000
10000
0
0
30
off
Asymmetric
0
Rebooting and Saving RF Module
73