Setting The Link Monitor Period - Wi-LAN AWE120-58 Ultima3 Series User Manual

Setting the Link Monitor Period

The Link Monitor Period determines the ratio of test data to message data that is sent when you run the link
monitor test. The higher the period number, the smaller the ratio of test data to message data. The following
diagram shows the ratios of test data to link data
Link Monitor Period Settings
Period Setting
See Performing Link Monitor Test (Normal
➧
To set link monitor period
1. From the Main Menu, select RF Station Configuration and press
Configuration menu is displayed.
H - Help
Operating Mode
RF Transmit Status
Link Monitor Period (0=OFF, 1-10000)
Test Mode Timer Minutes (1-1000)
Base Station Only Parameters
Maximum Remote Distance
Link Monitor Remote Station Rank
Remote Station Only Parameters
Throttle Enable
Throttle Level (1-100)
CIR Weight (1-5)
Output Power Control Mode
User Output Power Adjust Ceiling
Signal Margin (6-31) dB
Current Output Power Level Adjust
JUN 2002 Rev 02
1
Test Msg
2 Test Msg
3
Test Msg
Test = test data
Msg = message data
Mode), page 75 for information about running the Link Monitor test.
RF Station Configuration
Msg
Msg Msg
Normal Mode
unblocked
-> 1
5
5 Km
1
off
10 (640 kps)
1
off
-5 dB
15
-21
RF Station Configuration
Packet Ratio
(Test/Link)
50% (1/2)
33.3% (1/3)
25% (1/4)
. The RF Station
Enter
81