Setting Maximum Remote Distance (Base Station Only) - Wi-LAN Hopper Plus 120-24 Installation And Configuration Manual

Configuration

Setting Maximum Remote Distance (Base Station Only)

The Maximum Remote Distance setting is used to optimize dynamic polling by compensating for time delays
caused by long distances between the sending unit and the receiving unit.
In the base unit, the Maximum Remote Distance should always be set to the distance
➧
To set the maximum remote distance
1. From the Main Menu, select RF Station Configuration and press
Configuration menu is displayed.
Operating Mode
RF Transmit Status
Link Monitor Period (0=OFF, 1-10000)
Test Mode Timer (1-1000)mins
Base Station Only Parameters
Maximum Remote Distance
Link Monitor Remote Station Rank
Remote Station Only Parameters
Throttle Enable
Throttle Level (1-50)
2. Select Maximum Remote Distance and press
3. Press the arrow keys to set the distance of the furthest remote unit (5 km increments are used).
4. Press .
Enter
5. Press to exit to the Main Menu.
Esc
60
IMPORTANT
between the base and the farthest remote.
RF Station Configuration
Enter
. The RF Station
Enter
Normal Mode
unblocked
0
5
-> 5 Km
1
off
1
. The data field highlights.
Hopper Plus 120-24 Installation & Configuration Guide