Assigning Community Names - Wi-LAN Hopper Plus 120-24 Installation And Configuration Manual

Configuration

Assigning Community Names

Community names can be used to control SNMP access to the Hopper Plus. Community Name 1 has read
only access, and Community Name 2 has both read and write access. An SNMP manager can access and
configure any Hopper Plus unit on the network as long as the unit has the correct community names and
remote access is enabled (see
Default community names are presented in all Installation and Configuration guides
distributed by Wi-LAN. It is the responsibility of the customer to ensure that default
community names are changed to unique names at installation. Record all community
Community name
SNMP Community Name 1
SNMP Community Name 2
➧
To assign community names
1. From the Main Menu, select System Security and press
displayed.
SNMP Community Name 1
SNMP Community Name 2
Change User Password
Confirm User Password
Change Supervisor Password
Confirm Supervisor Password
Ethernet Access to Local Host
Wireless Access to Local Host
Auto Logout Minutes (1-120)
2. Select SNMP Community Name 1.
3. Type in name. (Valid community names are assigned using SNMP software.)
4. Press . The new name appears in the entry field.
Enter
5. Select SNMP Community Name 2.
6. Type in name. (Valid community names are assigned using SNMP software.)
7. Press . The new name appears in the entry field.
Enter
8. Press to exit to the Main Menu.
Esc
86
Allowing Remote Access and
WARNING
name changes.
Privileges
Read
Read and Write
System Security
-> public
netman
Press Enter to change password
Press Enter to confirm password
Press Enter to change password
Press Enter to confirm password
on
on
10
Configuration, page 89).
Default value
public
netman
. The System Security menu is
Enter
Hopper Plus 120-24 Installation & Configuration Guide