Logging Out - Wi-LAN Hopper Plus 120-24 Installation And Configuration Manual

Logout

Logging Out

There are two ways to log out of the main menu.
➧
To log out of the Main Menu
From the Main Menu, select Logout and press
or
1. Press the key on the keyboard until you reach the
Esc
Enter ESC to return to Main Menu
wilan> logout
2. Type logout at the wilan> prompt.
3. Press Enter to log out.
Setting Operating Mode with the MODE Button
The operating mode of a unit is usually selected from the RF Station Configuration menu (see
Operating Mode, page 49). However, operating mode can also be set using the MODE button located on the
back panel of the Hopper Plus 120-24. When you select an operating mode, the color of the MODE LED
indicates the operating mode and the color of the AIR LED indicates whether a unit is transmitting, receiving,
or listening.
The Hopper Plus starts up in Normal operating mode and the MODE LED is OFF. The following modes are
available.
Mode Function
Normal Mode Transmit and receive in both directions—normal operating mode
See
Transmit Test Transmit only
See
Receive Test Receive only
See
RSSI Test Received Signal Strength Indicator. Indicates fade margin data on
the AIR LED
See
DEC 2000 Rev 02
Enter
Performing Link Monitor Test (Normal
Performing Transmit and Receive
Performing Transmit and Receive
Performing the RSSI Test, page 57
.
command line.
wilan
Mode), page 52
Tests, page 55
Tests, page 55
Logout
Setting the
Mode LED
OFF
Red
Green
Orange
97