Accessing Units Via Telnet - Wi-LAN AWE120-58 Ultima3 Series User Manual

7. Type a default password (user or supervisor) or type your personal password if already have one.
Login Account
User
Supervisor
The Main Menu is displayed.

Accessing Units via telnet

➧
To access units via telnet
1. Ensure that the unit's Internet IP address has been configured, the unit has a working Ethernet
connection, and wire and remote access has been enabled (see
page 122).
2. Ensure that the VT100 Arrows feature in your telnet session is enabled. See
3. From the DOS prompt, type
C:>telnet <IP address>
where <IP address> is the IP address of the unit that you want to configure.
4. Press . The Login menu is displayed.
Enter
Wi-LAN AWE 120-58 Login
S/N:
MAC Address:
Software:
Hardware:
5. Type the default password (user or supervisor) or type your personal password.
The Main Menu is displayed.
JUN 2002 Rev 02
Default Password
user
supervisor
Serial-Number
001030000000
Rev 4.0.0 (Apr 20 2000 10:13:37)
Rev 4.0.0 (8MB SDRAM, 2MB Intel Flash)
Accessing the Main Menu
Privileges
Read Only
Read and Write
Allowing Remote Access and
Setting VT100
Configuration,
Arrows, page 34.
33