Accessing The Main Menu - Wi-LAN AWE120-58 Ultima3 Series User Manual

Configuration

Accessing the Main Menu

You can access the Main Menu of a AWE unit with a HyperTerminal ® session (via the Serial port) or a telnet
session. Most instructions provided in this chapter assume that you have opened a HyperTerminal session.
You can also configure the AWE 120-58 remotely using a standard web browser (see Appendix E: Configuration
Via the Web, page 177) or using SNMP (Simple Network Management Protocol) Manager software. See
Appendix D: SNMP, page 161 for information about SNMP.
Accessing the Main Menu with HyperTerminal ®
➧
To access the Main Menu with HyperTerminal
1. Disconnect power from the AWE unit.
2. Connect an AWE 120-58 Serial cable from a DB9 serial port on the PC to the Serial port on the AWE.
See Configuring a Base
3. Start HyperTerminal or other a terminal emulation program on the PC. See
HyperTerminal.
4. Set the terminal emulation program to emulate a VT100 terminal with the following settings.
• COM port
• Bits per second:
• Data bits:
• Parity:
• Stop bits:
• Flow control:
5. Reconnect the power to the AWE unit.
6. Press . The Wi-LAN AWE 120-58 Login menu is displayed.
Enter
Wi-LAN AWE 120-58 Login
S/N:
MAC Address:
Software:
Hardware:
32
Station, page 17.
PC serial port connected to AWE unit
9600
8
none
1
none
Serial-Number
001030000000
Rev 4.0.0 (Apr 20 2000 10:13:37)
Rev 4.0.0 (8MB SDRAM, 2MB Intel Flash)
Appendix B: Using
AWE 120-58 Ultima3 Series User Guide