Installing The Cover; Installing The Cover (Tower) - IBM xSeries 230 6RY Hardware Maintenance Manual

To replace the fan assembly:
1. Turn off the server and peripherals.
2. Remove the cover. See "Removing the cover, door, and bezel" on page 48 for
3. Determine which fan assembly to replace by checking the LED on each fan; a
4. Remove the fan assembly from the server by pressing the blue release latch for
5. Slide the replacement fan assembly into the server until it clicks into place.
6. Verify that the FAN LED on the diagnostic panel is not lit. If the FAN LED is
7. Replace the cover.
8. Turn on the server and peripherals.

Installing the cover

If you have a tower model, continue with "Installing the cover (tower)." If you
have a rack model, go to "Installing the cover (rack)" on page 71.

Installing the cover (tower)

To install the server left-side cover:
1. Align the cover with the left side of the server, about 25 mm (1 inch) from the
2. Insert the tabs at the top of the cover into the slots at the top of the server.
3. Hold the cover against the server and slide the cover toward the front of the
70
Hardware Maintenance Manual: xSeries 230 Models 6RY, 61Y
3
Fan assembly latch
4
Fan assembly
details.
lit LED indicates the fan to replace.
the fan and pulling the fan away from the server.
lit, reseat the fan.
1
Slots
2
Left-side cover
front of the server; place the bottom of the cover on the bottom rail of the
chassis.
server until the cover clicks into place.