IBM xSeries 230 6RY Hardware Maintenance Manual page 108

Cataloging the database in the managing system: If the manager is using a
remote database, catalog the node the database resides on and then catalog the
database to that node.
Once this step has been completed, the name of the Netfinity Manager database
will appear in the System Information Tools Database Selection window.
Deleting the database
The following information describes how to delete the database for all supported
operating systems.
Note: If your operating system is OS/2, refer to "Deleting the database on OS/2."
1. Start a DB2 command window.
2. Type
3. Press Enter.
Deleting the database on OS/2:
1. Insert the Netfinity Manager CD-ROM into the database server CD-ROM drive
2. Start an OS/2 window or full-screen session.
3. Make the CD-ROM drive the active drive.
4. Type the following command at the OS/2 prompt:
5. Press Enter.
100
Hardware Maintenance Manual: xSeries 230 Models 6RY, 61Y
v privilegecode is one of the following privilege codes:
– ALL
– ALTER
– CONTROL
– DELETE
– INDEX
– INSERT
– REFERENCES
– SELECT
– UPDATE
d. Press Enter to execute the command.
Note: Use PUBLIC or authorize only a specific ID or group name. Netfinity
Manager update programs use the DB2SQLC0 package and do not
require specific table privileges.
To revoke privileges, substitute REVOKE for GRANT in the command line.
To configure Netfinity Manager to discontinue export data through ODBC for
use on DB2, refer to "ODBC database support" on page 102.
DB2 DROP DATABASE databasename
where
databasename is the name of the database as specified during the database
installation.
(in this example, the CD-ROM drive is E).
Type E: and press Enter.
NETFINDB DELETE /DBNAME=databasename
where databasename is the name of the database as specified during NETFINDB
execution.