IBM xSeries 230 6RY Hardware Maintenance Manual page 31

Table 3. NDIS 2.01 (OS/2) driver messages for the Ethernet controller (continued)
PCNTND-6 Out of memory while allocating buffers.
PCNTND-7 A Protocol Manager device error occurred.
PCNTND-8 Bad status for the Protocol Manager.
PCNTND-9 Cannot find the PROTOCOL.INI entry.
PCNTND-10 The Protocol Manager Input Output Control (IOCTL) failed.
PCNTND-11 Protocol Manager registration failed.
PCNTND-15 Device not found.
PCNTND-16 PCI scan specified, device not found.
PCNTND-21 The adapter failed the checksum test.
PCNTND-23 WARNING: PCNET IRQ found = xx
PCNTND-24 WARNING: PCNET IRQ does not match PROTOCOL.INI.
Explanation: The driver could not allocate the requested buffers. Action: Check
your system configuration. Edit the PROTOCOL.INI file to reduce the number of
Txbuffers and Rxbuffers specified for the driver.
Explanation: The NDIS stack is not configured correctly. Action: Check and correct
your configuration.
Explanation: The NDIS stack is not configured correctly in the PROTOCOL.INI file.
Action: Check and correct your configuration.
Explanation: The NDIS stack is not configured correctly in the PROTOCOL.INI file.
Action: Check and correct your configuration.
Explanation: The NDIS stack is not configured correctly in the PROTOCOL.INI file.
Action: Check and correct your configuration.
Explanation: The NDIS stack is not configured correctly. Action: Check and correct
your configuration.
Explanation: The driver cannot find an Ethernet controller in the server. Action:
Verify that the Ethernet controller is enabled. If the Ethernet controller is enabled,
go to "Starting the diagnostic programs" on page 16 to run the diagnostic
programs.
Explanation: The driver cannot locate the Ethernet controller on the PCI bus.
Action: Verify that the Ethernet controller is enabled. If the Ethernet controller is
enabled, go to "Starting the diagnostic programs" on page 16 to run the diagnostic
programs.
Explanation: The driver cannot find an Ethernet controller. Action: Verify that the
Ethernet controller is enabled. If the Ethernet controller is enabled, go to "Starting
the diagnostic programs" on page 16 to run the diagnostic programs.
Explanation: The interrupt request (IRQ) setting (xx) in the PROTOCOL.INI file
does not match the hardware IRQ setting. Action: Remove the IRQ setting from the
PROTOCOL.INI file or change the IRQ setting in the PROTOCOL.INI file to match
the IRQ setting shown in the PCI Slot/Device Information selection of the
Advanced Setup menu in the Configuration/Setup Utility program.
Explanation: The interrupt request (IRQ) setting in the PROTOCOL.INI file does
not match the hardware IRQ setting. Action: Remove the IRQ setting from the
PROTOCOL.INI file or change the IRQ setting in the PROTOCOL.INI file to match
the IRQ setting shown in the PCI Slot/Device Information selection of the
Advanced Setup menu in the Configuration/Setup Utility program.
23
Diagnostics