Replacing A Fan Assembly - IBM xSeries 230 6RY Hardware Maintenance Manual

CAUTION:
The following label indicates a hot surface nearby.
3. Install a replacement power supply:
4. Turn on the server and peripheral devices.
5. If you have other options to install or remove, do so now; otherwise, go to

Replacing a fan assembly

Your server comes with two fan assemblies.
Attention:
cooling.
The following illustration shows the replacement of a fan assembly.
b. Remove the defective power supply by placing the handle of the power
supply in the open position (perpendicular to the power supply) and
pulling the power supply from the bay.
a. Place the handle on the replacement power supply in the open position;
then, slide the power supply into the chassis.
b. Gently close the handle on the power supply to seat the power supply in
the bay.
c. Plug the power cord for the power supply into the power cord connector.
d. Verify that the AC Power light and DC Power light are lit, indicating that
the power supply is operating correctly.
"Installing the cover" on page 70.
Replace a fan that has failed within 48 hours to help ensure proper
1
Fan assembly
2
Fan assembly latch
69
Installing options