No Beep Symptoms - IBM xSeries 230 6RY Hardware Maintenance Manual

Beep/Symptom
3-3-3 (No operational memory in system) 1. Install or reseat the memory modules, then do a 3 boot reset. See
Two Short Beeps (Information only, the
configuration has changed)
Three Short Beeps
One Continuous Beep
Repeating Short Beeps
One Long and One Short Beep
One Long and Two Short Beeps
Two Long and Two Short Beeps

No Beep symptoms

No Beep Symptom
No beep and the system
operates correctly.
No Beeps occur after
successfully completing POST
(The Power-On Status is
disabled.)
No ac power (Power supply ac
LED is off)
No beep and no video
System will not power-up
(Power supply ac LED is on)
FRU/Action
"Configuring the server" on page 31
2. DIMMs
3. System Board
1. Run Diagnostics
2. Run Configuration/Setup
1. DIMM
2. System Board
1. Processor
2. Optional Processor (if installed)
3. System Board
1. Keyboard
2. Repeating Board
1. Video adapter (if present)
2. System Board
1. Video adapter (if present)
2. System Board
1. Video adapter
FRU/Action
1. Check speaker cables
2. Speaker
3. System Board
1. Run Configuration/Setup, set the Start Options Power-On Status to enable.
2. Check speaker connection
3. Speaker
4. System Board
1. Check the power cord.
2. Power Supply (If two are installed, swap them to determine if one is
defective.)
3. Power Backplane
4. Hot-Swap Power AC Inlet Box
1. See "Undetermined Problems" on page 143
1. See"Power supply LED errors" on page 133
127
Symptom-to-FRU index