Controlling Access Using Ip Address (Ip Filtering); Control Access Using Mac Address (Mac Address Filtering) - Toshiba e-STUDIO 332s User Manual Advanced

Changing Network Settings From the Web Page
Click [Finish].
47
On the IP security policy properties
48
window, click [OK].
On the [Local Security Policy] window,
49
select the new IP security policy.
From the [Action] menu, select
50
[Assign].
Check that for the new IP security policy,
51
[Policy Assigned] is displayed as
[Yes].
Click [X] on the [Local Security Policy]
52
screen.
Controlling Access Using IP
Address (IP Filtering)
You can control access to the machine using the
IP address. You can set whether to allow
configuration or printing from the IP addresses
specified. By factory default, IP filtering is
disabled.
Note
Be sure to specify the correct IP address. If you specify a
wrong IP address, you cannot access the machine using
the IP protocol.
When you enable IP filtering, the access to and from a host
that is not specified in these steps is rejected.
Memo
You can use only IPv4 for IP filtering.
Access the machine's web page and log
1
in as the administrator.
Select [Admin Setup].
2
Select [Network Manager]>
3
[Security]>[IP Filtering].
Follow the on-screen instructions to
4
specify detailed settings.
Note
If nothing is registered in[Administrator's IP
Address to Register], you may not be able to access
the machine depending on the specified IP address
range.
If you use a proxy server, [Your Current Local
Host/Proxy IP Address] and the IP address of your
host may not match.
Click [Send].
5
The network card reboots to enable the new
settings.
Control Access Using MAC
Address (MAC Address
Filtering)
You can control access to the machine using the
MAC address. You can allow or reject the access
from the specified MAC addresses.
Note
Be sure to specify the correct MAC address. If you specify
the wrong MAC address, you cannot access the machine
via a network.
Memo
You cannot specify to accept or to reject for each address
individually.
Access the machine's web page and log
1
in as the administrator.
Select [Admin Setup].
2
Select [Network Manager]>
3
[Security]>[MAC Address Filtering].
Follow the on-screen instructions to
4
specify detailed settings.
Note
If nothing is registered in [Administrator's MAC
Address to Register], you may not be able to access
the machine depending on the specified MAC address.
If you use a proxy server, [Your Current Local
Host/Proxy MAC Address] and the MAC address of
your host may not match.
Click [Send].
5
The network card reboots to enable the new
settings.
- 152 -