Installing An Hp Host Bus Adapter - HP ProLiant ML350 Gen9 User Manual

Power up the server (on page 29).
19.
Do one of the following:
20.
For tower models, install the tower bezel (on page 31).
o
For rack models, install the security bezel
o

Installing an HP Host Bus Adapter

NOTE:
To install the component:
Do one of the following:
1.
For tower models, open and remove the tower bezel
o
For rack models, if installed, remove the security bezel
o
page 30).
Power down the server (on page 29).
2.
Remove all power:
3.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
4.
For tower models, place the server on a flat, level surface with the access panel facing up.
o
For rack models, extend the server from the rack (on page 33).
o
Remove the access panel (on page 31).
5.
Remove the air baffle (on page 33).
6.
Remove the fan cage (on page 36).
7.
Install the HP host bus adapter.
8.
The HP Smart Host Bus Adapter is not supported in PCIe slot 5.
("Security bezel option" on page 48).
("Remove the tower
("Remove the security bezel
bezel" on page 30).
(optional)" on
Hardware options installation 62