Detail/Adjust Item - JVC GY-HM650U Instructions Manual

Detail/Adjust Item

V/H Balance
For setting the H/V balance to enhance contour
(detail) in the horizontal (H) or vertical (V) direction.
H+1 to H+4:
0
Increasing the value enhances contour in the
horizontal direction.
V+1 to V+4:
0
Increasing the value enhances contour in the
vertical direction.
[Setting Values: H+1 to H+4, RNormal, V+1 to V+4]
Memo :
When [System] under [Record Format] is set to
0
"SD", this item is fixed at "Normal".
When [System] under [Record Format] is set to
0
"HD+SD", this item can be set during HD
recording, but will be fixed at "Normal" during SD
recording.
H Frequency
For specifying the correction frequency of the
horizontal contour. Set this according to the object.
High:
0
Emphasizes the high frequency range. Use this
when shooting objects with fine patterns.
Middle:
0
Emphasizes the intermediate frequency range.
Low:
0
Emphasizes the low frequency range. Use this
when shooting objects with large patterns.
[Setting Values: High, RMiddle, Low]
Memo :
When [System] under [Record Format] is set to
0
"SD", this item is fixed at "Low".
When [System] under [Record Format] is set to
0
"HD+SD", this item can be set during HD
recording, but will be fixed at "Low" during SD
recording.
V Frequency
For specifying the correction frequency of the
vertical contour. Set this according to the object.
Low:
0
Emphasizes the low frequency range.
Middle:
0
Emphasizes the intermediate frequency range.
High:
0
Emphasizes the high frequency range.
[Setting Values: Low, RMiddle, High]
Memo :
When [System] under [Record Format] is set to
0
"SD", this item is fixed at "Low".
(A P111 [ Record Format ] )
When [System] under [Record Format] is set to
0
"HD+SD", this item can be set during HD
recording, but will be fixed at "Low" during SD
recording.
"High" cannot be selected under the following
0
settings.
When [WResolution] is set to "1920x1080",
0
and [WFrame & Bit Rate] is set to "60i(HQ)"
or "50i(HQ)".
When [WResolution] is set to "1440x1080",
0
and [WFrame & Bit Rate] is set to "60i(HQ)",
"50i(HQ)", "60i(SP)" or "50i(SP)".
Skin Detail
For turning On/Off the Skin Detail function, which
is used to adjust the contour correction effect of the
colors captured.
Select "On" to soften the detail at areas where skin
tone is detected.
[Setting Values: On, ROff]
9 Level
For setting the level of contour correction (degree
of softening) using the Skin Detail function.
Decreasing the value increases the level of contour
correction (degree of softening).
[Setting Values: -1, R -2, -3]
9 Range
For adjusting the range of skin tone to trigger the
Skin Detail function.
Increasing the value increases the range.
[Setting Values: -5 to +5 (R0)]
101