Synchronizing Time Code On Another Camera - JVC GY-HM650U Instructions Manual

Synchronizing Time Code
on Another Camera
This camera recorder is equipped with a time code
input/output terminal ([TC] terminal).
Connect another camera recorder to the [TC]
terminal and synchronize to the time code.
1 Connect the [TC] terminal of the master
device with the [TC] terminal of the slave
device.
Set the [TC IN/OUT] switch of the master device
to "OUT", and the [TC IN/OUT] switch of the
slave device to "IN".
Master Device
Slave Device
(This Camera Recorder)
68
Settings and Operation of the Camera
Recorder
1 Set to Camera mode.
(A P18 [Operation Modes] )
2 Set [TC/UB] B [TC Generator] as follows.
Slave device:
0
Select "Free Run(Ext)".
Master device:
0
Select "Free Run".
3 Set LCD monitor or viewfinder to Display 1
screen.
4 Set the master device and run the time
code.
When the built-in time code generator is
0
synchronized with the external time code
data input, the Z icon on Display 1 screen
lights up.
When time code is not synchronized or time
0
[OUT]
code input is not available, the Z icon goes
out.
IN OUT
TC
4030 20
[IN]
Memo :
The built-in time code generator will continue
0
IN OUT
operation even when the master device is
TC
disconnected after synchronization.
User's bit will become data in the master device.
0
While the [TC] terminal is connected, the time
0
code may be out of synchronization when the
[A/V Set] B [Video Set] B [HDMI/SDI Out]
setting of the Master device and Slave device is
being changed.
(A P107 [ HDMI/SDI Out ] )
00: 00: 00.00
Jan 24 , 2012
12 :34 :56
ND 1 /64
10 0
P 13000K
5 . 6f t
AE 6
+
0
dB
F1. 6
1/ 100