JVC GY-HM650U Instructions Manual page 109

Test Tone
For specifying whether to output the audio test
signals (1 kHz) during color bar output.
[Setting Values: On, ROff]
INPUT1/2 Wind Cut
For selecting whether to cut the low frequencies of
the audio input signals (low-cut) when the [INPUT1/
INPUT2] switch is set to "MIC" or "MIC+48V".
Set this item to reduce wind noise from the
microphone.
Both:
0
Enables low-cut on both the [INPUT1] and
[INPUT2] terminals.
INPUT2:
0
Enables low-cut on the audio of the [INPUT2]
terminal only.
INPUT1:
0
Enables low-cut on the audio of the [INPUT1]
terminal only.
Off:
0
Disables low-cut.
[Setting Values: Both, INPUT2, INPUT1, ROff]
Int. Mic Wind Cut
For selecting whether to cut the low frequencies of
the audio input signals (low-cut) from the built-in
microphone. Set this item to "On" to reduce wind
noise from the microphone.
[Setting Values: On, ROff]
Equalizer
You can correct the characteristic and enhance the
sound of the connected microphone using this
equalizer setting.
For setting the audio frequency from a 5-band
equalizer.
Frequency:
0
100Hz, 330Hz, 1kHz, 3.3kHz, 10kHz
Variable level:
0
± 6dB (1dB step)
Memo :
Audio will be recorded in the characteristic set
0
in the equalizer.
Set all bands to "0dB" to bypass the equalizer.
0
When the equalizer level is set to +side, the
0
audio may be distorted. In this case, reduce the
recording level in Manual mode.
If the values of multiple frequencies are
0
changed, the specified levels and the actual
levels may be different due to interference
between the frequency bands.
This function is enabled only when both
0
[INPUT1/2 Wind Cut] and [Int. Mic Wind Cut] are
set to "Off".
Monitor
For setting the audio sound of the [x] terminal to
stereo or mixed sound when the [MONITOR]
switch on the LCD monitor is set to "BOTH".
Mix:
0
Outputs mixed sound (mixed sound of CH1 and
CH2) to both L and R.
Stereo:
0
Outputs stereo sound (outputs audio sound of
CH1 to L, and CH2 to R).
[Setting Values: RMix, Stereo]
Memo :
If both CH1 and CH2 are built-in microphones,
0
stereo sound is output from the [x] terminal
regardless of the [Monitor] setting.
Alarm Level
For selecting whether to turn on the warning tone
as well as setting the volume.
The warning tone is output from the monitor
speaker or [x] terminal.
[Setting Values: RHigh, Middle, Low, Off]
Audio On FULL AUTO
For setting whether to enable Auto for audio when
[FULL AUTO] is set to "ON".
SW Set:
0
Sets the audio recording mode following the
[CH1/CH2 AUTO/MANUAL] selection switch
setting.
Auto:
0
Sets audio recording mode to the forced auto
mode.
[Setting Values: SW Set, RAuto]
109