JVC GY-HM650U Instructions Manual page 67

Setting Time Code without Opening the
Menu
MENU/THUMB
AE LEVEL
CANCEL
Memo :
Settings cannot be made in the following cases.
0
[TC/UB] B [TC Generator] has been set to
0
"Regen".
Menu screen is displayed.
0
The camera recorder is not in the Camera
0
mode.
Setting Time Code
1 Set [TC/UB] B [TC Generator] to settings
other than "Regen".
(A P102 [ TC Generator ] )
2 Hold down the [MENU] button and press the
[FOCUS ASSIST/1] button.
The [TC Preset] setting screen appears.
During drop frame
3 Set the time code (hour, minute, second,
frame).
Use the cross-shaped button (HI) to place the
cursor at the item to set, then use the cross-
shaped button (JK) to change the values.
Memo :
Press the [OIS/2] button to reset each digit to "0".
0
The cursor moves to the time digit (left).
MENU/THUMB
CANCEL
FOCUS ASSIST/1 OIS / 2
TIME CODE
Cursor
During non-drop frame
4 Check the values and press the Set button
(R).
The time code is set and the screen returns
0
to the normal screen.
To cancel the setting, press the [CANCEL]
0
button.
Caution :
When the camera recorder is switched to Media
0
mode during editing, editing will be canceled
and the screen will close.
When editing the time code, operation of the
0
[FOCUS ASSIST/1] and [OIS/2] buttons that are
configured in [Main Menu] B [Camera
Function] B [User Switch Set] is disabled. The
[OIS/2] button functions as the number reset
button.
(A P97 [User Switch Set Item] )
Recording Time Code in Continuation of
the Recorded Time Code on SD Card
This camera recorder is equipped with the time
code reader.
1 Set [TC/UB] B [TC Generator] to "Regen".
When the camera recorder enters from
0
recording standby mode to recording mode,
it reads the time code already recorded on
the SD card and records the new time code
in continuation of that value.
The same data as the user's bit already
0
recorded on the SD card is recorded.
Memo :
When [TC/UB] B [TC Generator] is set to
0
"Regen", the framing mode of the time code
follows the settings in [TC/UB] B [Drop Frame]
instead of the clip settings.
(A P103 [ Drop Frame ] )
67