JVC GY-HM650U Instructions Manual page 29

1 Hold down the lock button (blue) at the
center of the [POWER ON/OFF(CHG)] switch
to set to "OFF(CHG)".
2 Attach the supplied battery.
Slide it in until you hear a click.
3 Connect the supplied AC adapter to the
[DC] terminal.
Open the cover of the [DC] terminal and connect
as shown in the diagram.
4 Connect the AC adapter to a power outlet.
The [POWER/CHG] lamp blinks during
0
charging and will go out after charging is
complete.
Remove the AC adapter after charging is
0
complete.
Memo :
Blinking of the [POWER/CHG] lamp during
0
charging indicates the charge level.
[POWER/CHG] Lamp
Orange blinking
(4 times per second)
Orange blinking
(3 times per second)
Orange blinking
(2 times per second)
Orange blinking
(1 time per second)
Light goes out
Removing the Battery
1 POWER
ON
OFF
(CHG)
MODE
1 Hold down the lock button (blue) at the
center of the [POWER ON/OFF(CHG)] switch
to set to "OFF(CHG)".
2 While pressing and holding the [BATT.
RELEASE] button, push up and remove the
battery in the direction of the arrow.
Caution :
Estimated Charging and Continuous
Operating Times
o Charging Time (supplied SSL-JVC50 battery
pack)
Approx. 4 h
Memo :
Charge Level
Less than 25%
Less than 50%
Less than 75%
Less than 100%
Fully charged
o Continuous Operating Time (supplied SSL-
2
JVC50 battery pack)
Approx. 1 hrs 50 mins
Memo :
Precautions for Batteries
Do not remove the battery when the [POWER
0
ON/OFF(CHG)] switch is "ON".
Do not insert or remove the DC cable when the
0
battery is in use.
Leaving the camera recorder unused with the
0
battery inside will deplete the battery power
even if you set the [POWER ON/OFF(CHG)]
switch to "OFF(CHG)". Remove the battery if
you are not using the camera recorder.
Use up the charge completely before you
0
charge the battery. If the battery is not fully
discharged before charging, the battery
capacity may drop after repeated cycles.
If the battery capacity drops due to repetitive
0
shallow charging and discharging, it may be
recovered by using up the charge completely
and then fully charging the battery again.
If you charge the battery immediately after using
0
while the battery is still warm, it may not be fully
charged.
It is recommended that you charge the battery
0
in an environment between 10 °C and 35 °C
(50 °F and 95 °F). The battery may not be fully
charged or the charging time may be prolonged
if charged under low temperatures (below 10 °C/
50 °F).
Actual operating times may differ depending on
0
the age of the battery, charging condition, and
operating environment.
Operating time is shortened in cold
0
environment.
The operating time may shorten when power
0
zoom is used, accessories are connected, or
when the LCD monitor is frequently used.
For purchase of spare batteries and battery
0
charger, consult your nearest JVC dealer.
Store the battery in a cool and dry place when
0
not in use. Do not expose the battery to high
temperatures (such as in a car under direct
sunlight). This will cause battery leakage and
shorten the battery life.
If the operating time shortens drastically even
0
after charging, the battery may be reaching the
end of its life. Replace the battery with a new
one.
29