About Your New Label Maker; Registering Your Label Maker; Getting To Know Your Label Maker - Dymo XTL 300 User Manual

About Your New Label Maker

® ™
With the DYMO XTL
multiple label types, including barcode labels, panel labels, and heat shrink tubes.
The label maker uses DYMO XTL
1/2", 3/4", or 1" (6 mm, 9 mm, 12 mm, 19 mm, or 24 mm). Labels are available in
a full range of temperature, chemical, and UV-resistant materials, including
continuous tape and pre-sized labels.
Visit www.dymo.com for information on obtaining labels and accessories for your
label maker.

Registering Your Label Maker

Visit www.dymo.com/register to register your label maker online. During the
registration process, you will need the serial number, which is located inside the
label compartment cover.
Register your label maker to receive these benefits:
 Notification of software upgrades by email
 Special offers and new product announcements

Getting to Know Your Label Maker

Become familiar with the parts of your label maker as shown in Figure 1.
3
2
1
1 Power/USB connectors 4
2 On/Off (Cancel printing)
3 Label exit slot
®
1 XTL 300
User Guide
300 electronic label maker, you can design and print
™
label cartridges in label widths of 1/4", 3/8",
4
5
9
LCD display
5 Cutter
6 Label compartment
cover release
6
7
8
Figure 1
7 Label compartment
8 Battery compartment
9 Lanyard loop