Cleaning The Sensors; Cleaning The Cutter Blade - Dymo XTL 300 User Manual

Cleaning the Sensors

Several sensors inside the label
compartment need periodic cleaning to
remove dust and other particles that may
have accumulated.
To clean the sensors
Remove the cleaning tool from inside
1
the label compartment cover.
Use the sponge end of the cleaning
2
tool to gently wipe the sensors using
an up and down motion (not side to
side). See Figure 12 for sensor
locations.

Cleaning the Cutter Blade

Clean the cutter blade each time you replace the label cartridge.
To clean the cutter blade
Press the label compartment release
1
and pull to open the cover.
Remove the label cartridge.
2
Insert a straightened paper clip (or
3
other pointed object) in the small hole
shown in Figure 13 to release the
cutter mechanism.
While pressing the paper clip down,
4
pull the cutter mechanism straight
out from the side of the label maker.
Place the cutter blade on a flat
5
surface with the blade side facing up.
Use a cotton swab and alcohol to
6
clean both sides of the blade. See
Figure 14.
The cutter blade is extremely sharp.
Use caution when cleaning.
After cleaning the blade, insert the
7
cutter mechanism back into the label
maker and press into place.
®
42 XTL 300
User Guide
Sensors
Press and hold
Pull straight
out
Cutter blades
Figure 14
Figure 12
Figure 13