Caring For The Label Maker; Cleaning The Label Maker; Cleaning The Print Head - Dymo XTL 300 User Manual

Caring for the Label Maker

Your label maker is designed to give you long and trouble-free service, while
requiring only occasional maintenance.
Clean your label maker from time to time to keep it
working properly.
A cleaning tool is located inside the label
compartment cover. The tool has two pads, a felt pad
for cleaning the print head and a sponge pad for
cleaning the sensors. See Figure 10.

Cleaning the Label Maker

 Clean the keypad, display, and outside of the label maker using a soft damp
cloth.
Do not put water or any other liquid directly on the display or keypad.
 Clean the inside of the label compartment using a small, soft brush or cotton
swab to wipe away stray particles.

Cleaning the Print Head

To keep printing clear and crisp labels, occasionally clean the print head. Use the
cleaning tool that came with your label maker.
The print head is very delicate, so use
care when cleaning.
To clean the print head
Press the label compartment
1
release and lift to open the cover.
Remove the label cartridge.
2
Remove the cleaning tool from
3
inside the label compartment
cover. See Figure 10.
Gently wipe the felt side of the tool
4
across the print head.
See Figure 11.
Replace the cleaning tool, insert
5
the label cartridge, and close the
cover.
®
41 XTL 300
User Guide
Figure 10
Cleaning tool
Cleaning
tool
Print
head
Figure 11